Introduction: How to Make a Dog in Tinkercad
Here is a step-by-step tutorial on how to create a dog in Tinkercad.
Supplies
If you want to print this project, then you will need a 3D printer. Other than that you just need to sign up for Tinkercad
Step 1: Legs
Click and drag four cylinders into the workspace and place them like they were legs.
Step 2: Body
Now add one more cylinder, this will be the body.
Step 3: Body#2
Rotate the new cylinder by 90 degrees
Step 4: Body #3
Now, make the body the size you want and change the height so it can rest on the legs.
Step 5: Body#4
Drag the body on top of the legs.
Step 6: Head
Now click and drag a sphere, this will be the head.
Step 7: Head#2
Choose the size of the head you would like then lift the head to stick on one side of the body.
Step 8: Eyes
Next, bring another sphere into the workspace.
Step 9: Eyes#2
Now, decide the size of the eyes you would like.
Step 10: Eyes#3
Copy and paste the one eye and make them a hole.
Step 11: Eyes#4
Now decide the height of the eyes to match the head.
Step 12: Eyes#5
Now place the eyes on the head in your desired position.
Step 13: Ears
Next, drag a half cylinder into the workspace.
Step 14: Ears#2
Change the angle of the ear, copy and paste it, then find the correct size for the ears.
Step 15: Ears#3
Take the ears and place them on the top of the head where you would like.
Step 16: Mouth
Next, place a "roof" shape into the workspace.
Step 17: Mouth#2
Now rotate the mouth so that it is upside-down and make the mouth into a hole.
Step 18: Mouth#3
Now place the mouth on the head, just below the eyes.
Step 19: Tail
Now drag the final cylinder into the workspace, this will be a tail.
Step 20: Tail#2
Next, take the tail and find the correct height and size.
Step 21: Tail#3
Finally place the tail, and it should look similar to this in the end.
This is an entry in the
First Time Author
Comments
4 days ago
Thanks for sharing your Tinkercad project :)